We started with R&D in 2010 and achieved our first prototype by 2012. We were later awarded the InnovAR prize from the Ministry of Science and Technology of Argentina on account of that development. We started selling our first printers in 2013. The model was called "Trimaker Beta" and we sold 42 of them. At the time, we were one of the only three companies in the world with DLP stereolithography technology.

In 2014 we released two other models to the market and became the first company to sell 3D printers in a retail channel (Staples) in Latin America. From than point on, we started focusing on the productive transformation required to scale the company. Towards the end of 2014 we were named one of the 100 most innovative young companies in the world (Innovators Forum, Moscow, Russia).

In 2015, Stylus SA (one of the largest consumer technology distributors in Argentina) entered the company as a shareholder and investor. We were then awarded a new recognition as one of the 50 mos...
We started with R&D in 2010 and achieved our first prototype by 2012. We were later awarded the InnovAR prize from the Ministry of Science and Technology of Argentina on account of that development. We started selling our first printers in 2013. The model was called "Trimaker Beta" and we sold 42 of them. At the time, we were one of the only three companies in the world with DLP stereolithography technology.

In 2014 we released two other models to the market and became the first company to sell 3D printers in a retail channel (Staples) in Latin America. From than point on, we started focusing on the productive transformation required to scale the company. Towards the end of 2014 we were named one of the 100 most innovative young companies in the world (Innovators Forum, Moscow, Russia).

In 2015, Stylus SA (one of the largest consumer technology distributors in Argentina) entered the company as a shareholder and investor. We were then awarded a new recognition as one of the 50 most innovative young companies in the world (K50, Silicon Valley, USA).

During 2016 we launched our fourth model: the "Trimaker Cosmos I". This was our first printer manufactured in series. The printed had a good reception from users, selling every single unit in stock.

In 2017 we started the development of our supplier in Shenzhen, China, with a member of our team located there. And finally in early 2018, we launched our fifth model: the "Trimaker Cosmos II". The printer is fully manufactured in China, and ready for export to any part of the world. Plus it can reach the target market with a competitive price & quality proposal in its segment.
More information

Employees

Fernando Fernandez
Admin
Fernando Fernandez CEO Entrepreneur with a Law degree. Postgrad in negotiation (Biz School)..